A little twist to this card is that the "Happy Christmas" sentiment is actually on the inside of the card. It shows through a strip of acetate on the front.
To start my card I cut the 8 1/2" x 5 1/2" card base from some heavyweight white cardstock. In addition I cut two strips of red (1" x 5 1/2"), two strips of green (1/2" x 5 1/2"), a white 2 1/2" x 2 1/2" square and a strip of clear acetate 2 1/2" x 5 1/2".
After scoring the card base at the 4 1/4" mark, I trimmed a 1 1/2" strip from the bottom and adhered it to the acetate strip. I trimmed that side of the card 1 1/4" from the top, adding Scor-Tape to the top of the acetate and the edge of the card.
After removing the Scor-Tape, I lined up the acetate/cardstock piece to the bottom of the card and pressed down on the taped sections -- creating the card base.
Next I cut the die-cut pieces from red and green cardstock . . .
. . . adding some darker color to the pieces. I sponged around the edge of the white square with red distress oxide ink.
Using a scallop punch, I trimmed down the red strips, adding some 1/8" Scor-Tape to the backs.
I then constructed my holly swag, using small foam pop dots to give dimension to the swag.
I then stamped the inside of the card, making sure that the sentiment was placed so that it would show through the acetate strip.
I then added the red/green strips to the outside of the acetate and constructed the swag panel and glued it on either side of the acetate strip. The "celebrate" sentiment was centered at the bottom of the card front.
CottageCutz dies used on this card are: